Operation; Installing The Saw Blade - Drill Master 62136 Owner's Manual And Safety Instructions

ASSEMBLY
Mounting
CAUTION! Choose a mounting surface that is
capable of supporting the weight of the Saw
and the workpiece.
1. Using the Base as a template, mark locations
of mounting holes.
2. Drill holes appropriate for the proper
hardware (sold separately), described under
Specifications on page 5, at the marked
locations.
3. Align mounting holes with pilot holes, then
secure the Base with the hardware.

Installing the Saw Blade

WARNING!
Wear heavy-duty work gloves during blade
installation.
Mount the blade so that its arrow matches the
arrow on the Blade Guard.
1. With the Saw OFF and unplugged, slide the
Blade Guard up and off of the Saw.
2. Place the Saw Blade onto the Arbor (16).
Slide on the Washer (18), then secure with
Screw (19).
3. Slide the Blade Guard back on.
Item 62136 For technical questions, please call 1-888-866-5797.

OPERATION

WARNING!
Wear ANSI-approved safety goggles during use.
Setting the Angle
1. Loosen the Angle Adjusting Knob, then
move the Vice Screw until the angle arrow
aligns with the correct angle. Tighten Angle
Adjusting Knob.
2. Place the workpiece between the Jaws, then
rotate the Vice Screw clockwise to tighten the
Moveable Jaw until the workpiece is secure.
Angle
Adjusting
Knob
Vise
Screw
Figure B
Cutting
1. Plug in the Saw and turn the Power Switch to
its ON (I) position.
2. Allow the Saw Blade to reach maximum
speed.
3. Push down on the Safety Lever Button to
release the Safety Lever, then pull down the
Handle to begin cutting.
4. When the cut is complete, pull the Handle up
until the Safety Lever engages.
5. Turn the Saw to its OFF (O) position.
Fixed
Jaw
Moveable
Jaw
Page 7