Table of Contents
Advertisement
1.
Press the SETUP/MENU button on the remote control.
•
Each time the button is pressed, the mode switches between INPUT and SETUP OFF.
2.
Press the ▲▼ buttons to select OPTION, and then press the
ENTER button.
3.
Press the ▲▼ buttons to select AUTO CALIBRATION, and
then press the ENTER button.
4.
Press the ▲▼ buttons to select MEASUREMENT, and then
press the ENTER button.
•
To create the optimal 5.1 channel sound fi eld, the selections
are in the following sequence:
L ➞ C ➞ R ➞ SR ➞ SBR ➞ SBL ➞ SL ➞ SW
•
MODE ON : The auto calibration mode is set to on.
MODE OFF: The auto calibration mode is set to off.
To cancel the Auto Calibration setup.
This will be automatically reverted if you press the RETURN button.
•
If auto calibration error occurs, see "Auto Calibration Error List" on page 59.
✎
NOTE
Setting the calibration takes about 3 minutes.
Because the volume level of the tone is fi xed during the Auto Calibration setup, you cannot adjust
the volume using the volume control.
If the ASC microphone is disconnected during the Auto Calibration setup, the setup will be
cancelled.
You can also press the ASC button on the remote control to use this function.
If Dolby Pro Logic ||z is set to ON, the selection are in the following sequence :
FL CEN FR SR FHR FHL SL SW.
HW-D600_D650S_ELS_0603.indd 43
HW-D600_D650S_ELS_0603.indd 43
43
English
2011-06-03
2011-06-03
12:40:36
12:40:36
Advertisement
Table of Contents
