KTM 1190 Adventure Owner's Manual page 207

22 TROUBLESHOOTING
Faults
Engine turns but does not start
Engine dies during the trip
The engine warning lamp lights
up/flashes
The ABS warning lamp lights up
High oil consumption
The battery is discharged
Possible cause
Defect in fuel injection system
Fuel quality is insufficient
Lack of fuel
Defect in fuel injection system
Defect in fuel injection system
ABS fuse is blown
Wheel speeds of front and rear wheels
differ greatly
Malfunction in ABS
Engine oil level too high
Engine oil too thin (low viscosity)
A power consumer is connected to the
socket/ACC1.
The hazard warning flasher is switched
on
Battery is not charged by alternator
Ignition not switched off when vehicle
was parked
Action
–
Read out the fault memory using the KTM diag-
nostics tool.
–
Add suitable fuel.
–
Refuel. ( p. 98)
–
Read out the fault memory using the KTM diag-
nostics tool.
–
Read out the fault memory using the KTM diag-
nostics tool.
–
Change the fuses in the fuse box. (
–
Stop, switch off the ignition, start again.
–
Read out the fault memory using the KTM diag-
nostics tool.
–
Check the engine oil level. (
–
Change the engine oil and filter, clean the oil
screens. ( p. 191)
–
Disconnect the power consumer from the
socket/ACC1.
–
Recharge the battery.
–
Switch off the hazard warning flasher.
–
Recharge the battery.
–
Check the charging voltage.
–
Recharge the battery.
205
p. 169)
p. 190)
( p. 163)
( p. 163)
( p. 163)