Status Led; Dust And Water Resistance; Set Up Your Mobile Hotspot - NETGEAR AirCard 815S User Manual

Status LED

The status LED indicates data connection status:
• Blue, slow blink. The mobile hotspot is ready.
• Blue, double-blink. The mobile hotspot is transferring data.
• Amber, slow blink. The mobile hotspot is not connected to the network.

Dust and Water Resistance

The mobile hotspot's rugged design is dustproof, shock resistant, and water resistant (IP65
and MIL-STD-810G drop & shock) when both RF doors are closed and the back cover is
1
tightly shut. The mobile hotspot is not submersible but will resist a hard stream of water for
up to 30 seconds (each side).

Set Up Your Mobile Hotspot

The mobile hotspot comes with a preinstalled SIM card.

To set up your mobile hotspot:
1. Remove the back cover.
2. Insert the battery.
Gold pins
1. Meets US MIL-STD-810G for shock resistance. Certified IP65 for protection against dust and water jets. Device will not operate under water and
should be dried as quickly as possible when wet. Shock-resistant when dropped from ≤ 4 feet onto flat surface. Device may not perform as shown in
all extreme conditions.
AirCard 815S Mobile Hotspot
Get Started
9