Connecting The Power Cord - HP Vectra SERIES Quick User Manual

Connecting the Power Cord

For your safety always connect equipment to a grounded wall outlet. Always use a
WARNING
power cord with a properly grounded plug, such as the one provided with the
equipment, or one in compliance with your national safety standards. This equipment
can be disconnected from the power by removing the power cord from the power outlet.
This means the equipment must be located close to an easily accessible power outlet.
1 Remove the warning label covering the PC's power connector, and
ensure that the voltage setting is correct for your country. (The
voltage is set during manufacture and should already be correct.)
2 Connect the power cords to the rear of the monitor and the computer.
(The connectors are shaped to go in one way only.)
3 Connect the monitor's power cord and the computer's power cord to a
grounded outlet.
Note Hewlett-Packard does not support power supply upgrades. Power supply installation
information is only intended to assist with the replacement of a defective power supply unit.
For you safety, only replace your power supply unit with the one provided by HP Support
Services.
Setting Up and Using Your PC
Voltage
Selection
Switch
7