15
COOLING SYSTEM
–
Remove bleeder screw
–
Tilt the vehicle slightly to the right.
–
Pour in coolant until it emerges without bubbles at the vent hole, and then mount and
tighten bleeder screw
Alternative 1
Coolant (
Alternative 2
Coolant (mixed ready to use) (
B00985-10
–
Fill the radiator completely with coolant. Mount radiator cap
–
Lean the vehicle on the side stand.
–
Check the coolant level in the compensating tank. (
Danger
Danger of poisoning Exhaust gases are toxic and inhaling them may result in
unconsciousness and/or death.
–
–
Start the engine and run it until the 5th bar of the temperature indicator lights up.
–
Stop the engine and allow it to cool down.
–
When the engine is cool, check the coolant level in the radiator and, if necessary, add
coolant.
–
Check the coolant level in the compensating tank. (
.
2
immediately.
2
p. 168)
p. 168)
When running the engine, always make sure there is sufficient ventilation,
and do not start or run the engine in an enclosed space without an effective
exhaust extraction system.
.
1
p. 127)
p. 127)
130