KTM 690 SMC Owner's Manual page 107

MAINTENANCE WORK ON CHASSIS AND ENGINE
–
Check parts for damage and wear. Replace damaged or worn parts.
–
Remove the bushing
seal ring .

Long-life grease (
–
Clean and grease the thread of the wheel spindle and nut
Long-life grease (
–
Mount the rubber damper and rear sprocket carrier in the rear wheel.
600628-10 –
Place the rear wheel in the swingarm and bring the brake disc on the brake caliper into
contact.
–
Push the rear wheel forward as far as possible and place the chain on the rear sprocket.
–
Mount the wheel spindle, chain adjuster and nut.
Guideline
In order for the rear wheel to be correctly aligned, the markings on the left and right
chain adjusters must be in the same position relative to the reference marks
Info
Fit the chain left and right adjusters
100270-10
–
Tighten nut
Guideline
Nut, rear wheel spindle
–
Operate the foot brake lever repeatedly until the brake linings lie on the brake disc and
there is a tight spot.
–
Taking rear from work stand. (
. Clean and grease the roll surfaces of the bushing and the shaft

S. 177)
S. 177)
.

S. 64)
.

in similar positions.

M25x1.5 90 Nm (66.4 lbf ft)
105
.
