Related Manuals for Rear view safety RVS-718-7ML
Summary of Contents for Rear view safety RVS-718-7ML
- Page 1 A S a f e F l e e t B r a n d Instruction Manual G-Series Rear View Replacement Mirror Monitor with 7.3” Mirror Link Display RVS-718-7ML Rear View Safety, Inc. © 2016 Reverse With Confidence ™...
-
Page 2: Table Of Contents
Warranty & Disclaimer......27-28 Notes......29 Rear View Safety... -
Page 3: Introduction
NOTE! Please read all of the installation instructions carefully before installing the product. Improper installation will void manufacturer’s warranty. Congratulations on purchasing a Rear View Backup Camera System! With this manual you will be able to properly install and operate the unit. The Backup Camera System is intended to be installed as a supplement aid to your standard rear view mirror that already exists in your vehicle. -
Page 4: Safety Information
Rear View Camera System. If you back up while looking only at the monitor, you may cause Rear View Safety... - Page 5 INSTALLATION: • Electric shock or product A short circuit or disconnected wire malfunction may occur if this may cause a fire. product is installed incorrectly. • While installing the Rear View System be careful with the wire • Use this product within the positioning in order to avoid wire voltage range specified.
- Page 6 Install split grommets where applicable. Step 3: Once all cables and wiring have been properly routed, perform a system function test by temporarily connecting the system. Rear View Safety...
-
Page 7: Monitor Information
Monitor Buttons 1.4 Opera ng panel 1. 7.3” display screen 2. Front light sensor 3. ON/OFF button for screen display. Short press to adjust screen brightness 7.3 inch ultra high brightness display screen in reverse mode Front light sensor 4. Power indicator Turn on/off... - Page 8 Rear View Safety...
- Page 9 8. Speaker 9. Connector 10. Special Bracket 11. Red To ACC+ 12. Black To GND 13. 5 Pin Camera Connectors 14. Audio Cables 15. Trigger Line 1 16. Trigger Line 2 17. Rear Signal A S a f e F l e e t B r a n d Reverse With Confidence ™...
-
Page 10: Before You Begin
Do not run the cable over sharp edges, do not kink the cable, and keep away from HOT and rotating parts. Fasten all cables and secure all excess cable. Connect camera to the camera extension cable running inside the vehicle. Rear View Safety... -
Page 11: Wiring
Wiring After connecting the camera to the “camera cable” the camera should be plugged into AV2. Connect the RED 12V power wire to an ignition power source and the BLACK 12V ground wire to a chassis ground. The GREEN wire is the REVERSE trigger wire. Connect this wire to the vehicle’s backup light circuit to activate the rear-view image whenever the vehicle shifts into reverse. -
Page 12: Installation Guide
There are many ways to remove the original rear view mirror. Do not force the mirror off the bracket. The manufacturer will not be responsible for any damage caused to your car by improper mirror installation. Rear View Safety... - Page 13 Bracket Type 2.2 Special bracket If the mirror monitor doesn’t fit in your vehicle, please contact us. We We have many kinds of brackets. One of them must suit for your car, and we are not going to have many different kinds of brackets and adaptors. go through anymore examples, because the space is limited.
- Page 14 Black to GND Red to ACC +12V FUSE Black to GND Black to GND Red to ACC +12V 5 Pin Camera Connector Black to GND Red to ACC +12V Left camera 5 Pin Camera Le video Connector Audio Cables Rear View Safety...
-
Page 15: Gridlines
Chapter three: Adjustable Guideline Adjustable Grid Lines Generally, to help drivers estimate the distance from obstacles, there 3.1 About guide line are three lines for reference -red, yellow and green. These three lines are displayed on the monitor when car is reversing. The green line is 3m Generally, to help drivers es�mate the distance from obstacles, there are three lines for from the back of car and the yellow line is 2m. - Page 16 Right posi on Wrong posi on Display on the monitor d on Press the bu on to choose L or R adjustable guide line Clockwise Le� Right Down An�-clockwise Remote control Move the guide line Rotate the guide line Rear View Safety...
-
Page 17: 4.1 Remote Control
Chapter Four: Menu Se ng Remote Control 4.1 Remote control The remote must be used to change menu settings. The menu only can be set by remote control, and kindly check its deni on as below. Menu parameter increase Enter picture menu Menu parameter decrease Guide line up Guide line le... -
Page 18: Basic Settings
The defaulted se ng is 50, ranging from 0 to 100, and only CVBS signal can work. Contrast Level 4.2.3 CONTRAST ADJUSTMENT The defaulted se ng is 50, ranging from 0 to 100, and only CVBS signal can work. Rear View Safety... - Page 19 Scale Adjustment 4.2.4 SCALE ADJUSTMENT Scale function will only work with gridlines. Choose “ON/OFF.” It's only for the model with guide lines, and no such se ng for those without such func on. ON is defaulted se ng, and you can manually set it to OFF. Default is “ON.”...
-
Page 20: Mirror Link
Wi-Fi on your phone, then search equipment in the phone's wireless projec on func on, connect the device according to the wireless device names displayed on the screen , the step shown on next page. is as below: “M”bu on Rear View Safety... - Page 21 tap here tap here tap here After the mirror link is connected, press the “CH” button to toggle between A er nishing the connec on, then the phone screen projected onto the rear view mirror, single and dual display modes. you can press “CH”...
- Page 22 12345678. A er nishing Wi-Fi connec on, bring up the shortcut menu, click on the AirPlay func on, select the device name, and open the mirroring. Tap here Wi-Fi name Turn on it Tap here Rear View Safety...
-
Page 23: Display Modes
5.2.2 F A er nishing the connec on, then the phone screen projected to the rear view mirror, you can press “CH” on TP bu on to choose “ double mobile dual mode” or “single-screen mode”. 5.2.3 F Channel Switching After the mirror link is connected, press the “CH”... - Page 24 Full Side Camera Display 5.2.2 Full VIDEO1 screen display Full Mirror Link Display 5.2.3 Full MOBILE screen display Rear View Safety...
- Page 25 Side Camera/Mirror Link Dual Display Please no 5.2.4 VIDEO1 and MOBILE display simultaneously 1. Both Rev Video+mirr camera full 2. Power on has eight st states. 3. There ar 1) The rst of triggerin powering o next �me; 2) The seco turn light o of VIDEO w when the t...
-
Page 26: Triggering
1. Reversing your vehicle will trigger your rear camera. 2. The mirror will automatically switch to the full camera display when the brake or turn signals are used. 3. When a camera/mirror link dual display is shown, gridlines will not be dis- played. Rear View Safety... -
Page 27: Warranty & Disclaimer
OTHERS OR THE UNAUTHORIZED USE OF NONCONFORMING PARTS; THE DAMAGE IS DUE TO NORMAL WEAR AND TEAR, THIS DAMAGE IS DUE TO ABUSE, IMPROPER MAINTENANCE, NEGLECT OR ACCIDENT; OR THE DAMAGE IS DUE TO USE OF THE REAR VIEW SAFETY, INC. SYSTEM AFTER PARTIAL FAILURE OR USE WITH IMPROPER ACCESSORIES. - Page 28 FOR ANY INJURY, LOSS OR DAMAGE, INCIDENTAL OR CONSEQUENTIAL, ARISING OUT OF THE USE OR INTENDED USE OF THE PRODUCT. IN NO EVENT SHALL REAR VIEW SAFETY AND/OR ITS AFFILIATES HAVE ANY LIABILITY FOR ANY LOSSES (WHETHER DIRECT OR INDIRECT, IN...
-
Page 29: Notes
Notes Reverse With Confidence ™... - Page 30 A S a f e F l e e t B r a n d If you have any questions about this product, contact: Rear View Safety, Inc. 1797 Atlantic Avenue Brooklyn, NY 11233 800.764.1028 IN NO EVENT SHALL SELLER OR MANUFACTURER BE...
Need help?
Do you have a question about the RVS-718-7ML and is the answer not in the manual?
Questions and answers