Display Alarms And Shift Lights - Seat Leon Cup Racer Technical Manual

TECHNICAL MANUAL LEON CUP RACER
8 High beam
Wiper
9
Windscreen water
10
11 Drink
-- + Tip up // Tip down
CAN info
Notes:

Although it is possible to uncouple completely the steering wheel from the column with the engine
running, is not advisable (causes fault messages on the OBD).
 Be careful with the "Safety brake signal button". This button permits putting in Neutral the gear
lever although the brake pedal is not pressed. Take care and advise the people around the car
because wheels may move.
2.3

Display alarms and shift lights

Car delivery alarm configuration
Notes:

LED 1 yellow alarm light: Low oil pressure. If no red alarm follows you can continue. If alarm
disappears you can continue pushing. Check the oil level when back into the pit.

LED 2 red alarm light + POP UP: Very low oil pressure. Big risk to break the turbo or to damage
the engine. Seat Sport recommends slowing down and entering to the pit-lane or stopping in a
safe place.

LED 3 purple alarm light: Battery voltage low warning. You can continue, check the alternator
and the alternator poly-V belt.

LED 4 yellow alarm light: Fuel pressure low warning. You can continue, check the fuel level.

LED 5 yellow alarm light: water temperature high. Pay attention, drive out of slipstream and
keep an eye on the values. If no red alarm follows you can continue. If alarm disappears you can
continue pushing.

LED 6 red alarm light: water temperature too high. Drive out of slipstream and keep an eye on
the values. Some torque reductions will appear but you can continue.

LED 6 red alarm + POP-UP message: Critical water temperature. Seat Sport recommends
slowing down and entering to the pit-lane or stopping in a safe place, to avoid damaging the
engine.

LED 7 white alarm light: Gearbox oil temperature high. Drive out of slipstream and keep an eye
on the values if not some torque reductions will appear. You can continue.

LED 8 blue alarm light: Intake air temperature high. Drive out of slipstream and keep an eye on
the values if not some torque reductions will appear. You can continue.
Short push to flash
Long push to toggle on/off
Toggle to activate
Push to activate water splash + wiper activation
Activates water pump
Note: Pump not supplied by SSp
Orange led informs when tip up or down signal has been activated
Usual status: LED off
LED on when there is a problem of CAN Bus communication
12 de 44