Panasonic VDR-M70EG Service Manual page 68

VDR-M70EG / VDR-M70EB / VDR-M70GC / VDR-M50EG / VDR-M50EB / VDR-M50GC
(7) Side Case L, LCD Unit, and SWL2 Circuit Board
1) Unplug the connector. Be sure to hold the connector using tweezers, etc. when unplugging it.
Pulling the cable when unplugging the connector could cause wire disconnection.
2) Remove five screws [D].
3) Remove two screws [E], and then remove the LCD unit (b) and ground plate (d) from side case-L
(a).
4) Disconnect the one flat cable.
5) Remove two screws [D], and then remove the SWL2 circuit board (c).
Note:
Take great care when handling the LCD unit The LCD unit has an LCD panel that is a precision
component. Subjecting it to impact could result in a fault.
(a) Side case-L
(b) LCD unit
(c) SWL2 circuit board
(d) Ground plate
(e) L cover
(f) SWL3-H/SWL3 circuit board
Downloaded From CamcorderManual.com Panasonic Manuals
[D] M1.7x4 (Black)
[E] M2x5 (Silver)
2) [D]
4)
(a)
2) [D]
(d)
(b)
Fig. 5-3-9
(1)
(1) Unlock
(2)Pull
(1)
(2)
(c)
(e)
3) [E]
68
5) [D]