KTM 2016 RC 250 Owner's Manual page 117

14 WHEELS, TIRES
–
Clean the thread of the wheel spindle and screw
–
Position the front wheel and insert the wheel spindle.
The brake linings are correctly positioned.
–
Mount and tighten screw
Guideline
Screw, front wheel spindle
–
Position wheel speed sensor
Guideline
Screw, wheel speed sensor holder
–
Mount and tighten screws
–
Operate the hand brake lever repeatedly until the brake linings are in contact with the
brake disc and there is a pressure point.
–
Take the motorcycle off of the front wheel stand. (
–
Pull the front brake and compress the fork forcefully a few times.
The fork legs straighten.
–
M00463-10 Tighten screws
Guideline
Screw, fork stub
Finishing work
–
Take the motorcycle off of the front wheel stand. (
–
Take the motorcycle off of the rear wheel stand. (

.

in the drill hole. Mount and tighten screw

.

.
 .
M8 26 Nm
(19.2 lbf ft)
M6 7 Nm (5.2 lbf ft)
p. 80)
M8 15 Nm
(11.1 lbf ft)
p. 80)
p. 78)
115

.