Table of Contents
Advertisement
6.Idler gear installation
(1)Lubricate the idler gear with engine oil.
(2)Install the idler gear in position with its
"3","2"and "11"marks in alignment
with the "33"mark on the fuel injection pump
camshaft gear, the "22"mark on the
camshaft gear and the "1"mark on the
crankshaft gear respectively.
(3)Check the backlash of the gears. Make
reference to "Timing gear backlash
measurement"(page 38).
7.Timing gear case installation
(1)Coat the gasket with adhesive and put it
in position the front plate.
(2)Lubricate the oil seal lip with engine oil.
(3)tighten the bolts that hold the timing gear
case.
8.Crankshaft pulley nut tightening
(1)Install two bolts(M12x1.25)in the
flywheel bolt holes in the crankshaft and
hold the crankshaft.
(2)Tighten the crankshaft pulley nut to the
specified torque.
Tightening torque
Check the strength of the bolts and bar
used for holding the crankshaft.
9.P.T.O. gear installation
Install the P.T.O. gear in position in the
timing gear case with the side that has no oil
hole toward the rear of the engine.
10.Speedometer driven gear installation
(1)Install the O-ring in the groove in the driven
gear sleeve.
(2)Install the speedometer driven gear in position
in the cylinder block while rotating it or the
camshaft.
49
17.5
2.5 kgf•m
(127
18 lbf•ft)
[172
25N•m]
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
