Fuel Injection Pump Camshaft; Tappets; Cam Contact Face; Idler Gear - Cub Cadet 7360SS Service Manual

Item Standard
Lobe height 35.72
of camshaft (1.4063)

2.Fuel injection pump camshaft

Measure the lobe height and base circle as
shown in the illustration. Subtract the base
circle from the height to find the lobe life.
If the lobe lift exceeds the limit, replace the
camshaft.
Item
Lobe height of
fuel injection
pump camshaft.

3.Tappets

(1)Cam contact face

Check the cam contact face of each tappet for
abnormal wear. Replace the tappet if the face
is defective.
Unit:mm(in.)
Limit
34.72
(1.3669)
Unit:mm(in.)
Standard Limit
44(1.73) 43(1.69)
(2)Clearance between tappet and cylinder
block
Measure the diameter of the tappet and the
bore in the cylinder block for the tappet to
find the clearance. If the clearance exceeds the
limit, replace the tappet.
Item
Clearance between
tappet and cylinder block

4.Idler gear

(1)Clearance between idler gear and shaft
measure the bore in the idler gear for the
shaft and the diameter of the shaft to find the
clearance. If the clearance exceeds the limit,
replace the gear or shaft whichever is badly
worn.
Item
Clearance between
idler gear and shaft
85
Unit:mm(in.)
Standard
0.15(0.0059)
Unit:mm(in.)
Standard Limit
0.03 to 0.0 0.20
(0.0012 to 0.0028) (0.0079)