Resolved Issues; Issues Resolved In Release 6.0 - Nortel 5000 Series Release Notes

Resolved issues

The following table lists the issues resolved for release 6.0:

Issues resolved in release 6.0

The following table describes the issues in previous software releases for the
Ethernet Routing Switch 5000 Series that have been resolved in release 6.0.
Table 6
Issues resolved in Ethernet Routing Switch 5000 Series release 6.0
Change Request Number
Q01193666
Q01200004
Q01295448
Q01305224
Q01324425
Q01334161
Copyright © 2008., Nortel Networks
.
Documented issue
Pinging the virtual IP address from the master VRRP routing switch is
now supported.
Ping delay resolved.
With release 6.0, when configuring IPFIX, the Exporter IP is not
configurable. Therefore the exporter address is one of the routable
interfaces. Resolved.
Each port on the 5520 is restricted to 11 interface IDs. Depending on
your configuration, you may be unable to select the complete list of
interface applications on an Ethernet Routing Switch 5520 because of
the permitted number of interface IDs. Resolved.
A PC can disappear from the Nortel SNA client list after you perform a
Time Domain Reflectometry (TDR) test on a Nortel SNA dynamic port.
Workaround: Nortel recommends that you avoid running a TDR test
on a Nortel SNA port. Resolved.
When a port is NSNA enabled, the CLI allows you to disable CIST
learning even though that port belongs to CIST and MSTI.
Whenever a port is added to a new VLAN in RSTP or MSTP mode, it
automatically becomes STP enabled for that group. This is different
from the Nortel STPG mode, where the port is not automatically
enabled on the STP group. Resolved.
Nortel Ethernet Routing Switch 5000 Series
Release Notes — Release 6.0
NN47200-400 04.01 Standard
6.0 12 December 2008
25