Nortel 5000 Series Release Notes page 26

26 Resolved issues
Change Request Number
Q01376770
Q01378866
Q01386170
Q01402433-01
Q01402425-01
Q01387506-01
Copyright © 2008., Nortel Networks
.
Documented issue
Note that you should not disable global IP routing on the 5500 Series
switch when the switch has an IST enabled.
The CLI returns a reminder message if you attempt to disable IP
routing with an IST enabled. The JDM also returns an error message,
although the message is more generic than that returned from the
CLI. Resolved.
When VLAN configuration control (VCC) is set to automatic, avoid
changing tagging on ADAC ports. Resolved.
An ACG file will display error messages for RIP settings when you
attempt to download the file if the file contains more then 64 IP
VLANs. If using the CI, the download stops at the first error message.
Resolved.
The CLI commands used to set the CLI password on a stack are not
displayed when using ? to request CLI help for the command (that is,
cli password ?).
The omitted commands are:
cli password stack serial <password>
•
cli password stack telnet <password>
•
cli password stack read-only <password>
•
cli password stack read-write <password>
•
Resolved.
MAC address security in a stack is limited to the highest port number
of the base unit if that unit is a 5510-24T or 5530-24TFD model. Port
numbers higher than 24 are not allowed when a 5510-24T is the base
unit and ports higher than 26 are not allowed when a 5530-24TFD is
the base unit.
For example, if the stack consists of a 5530-24TFD as the base unit
and unit 2 is a 5510-48T, ports 2/25 through 2/48 cannot be used for
MAC-based security in learning mode.
Note: Also see CR Q01387506-01 directly below.
Resolved.
In hybrid (mixed) stack configurations, Nortel recommends that the
higher model number unit be made the base unit. In instances where
a 5530-24TFD is to be part of the stack, Nortel recommends that this
unit be made the base unit to utilize the full range of features present
on this unit.
Note: If running MAC security, ensure you have a 48-port unit as the
BU (see CR Q01402425-01 directly above).
Resolved.
Nortel Ethernet Routing Switch 5000 Series
Release Notes — Release 6.0
NN47200-400 04.01 Standard
6.0 12 December 2008