Toyota 1986 Landcuiser Repair Manual page 97

AU TOMATIC T RANSMISSI ON - On-Vehicle Repair
A T·23
5. INSTA LL FOUR CENTER SUPPORT A PPL Y GASKETS
6. INSTA LL VA LV E BODY
(See
page AT·191
7.
IF THR OTTLE CABLE IS NEW, PA INT MA RK ON
INNER CABLE
NOTE: New cables do not have a cable stopper
installed.
Therefore to make adjustment possible, paint a mark as
described below.
(al Connect the throttle cable to the throttle cam of
valve body.
(bl Pull the inner cable lightly until resistance is felt, and
hold it.
(c) Paint a mark
as
shown, about 4 mm (0.16 in,) in
width.
(dl Pull the inner cable fully, measure the cable stroke.
Cable stroke: 33 :1: 1 mm (1,30
t
0,04 in. I
8. CONN ECT THR OTTLE CAB LE
(a) Connect the cable to the throttle linkage.
(bl Connect the cable housing to the bracket on the valve
9 . AD JUST THR OTT LE CAB LE
(See
page AT-61
10. FI LL T RANSM ISSION WI TH A TF
Ad d 6liters (6.3 US
qU,
5.3 Imp. qtsl of ATF .
CAUTION : Do not overfill.
Fluid type: A TF DEX RONI!> n
n. CH ECK FLUID L EVEL
(See
page AT·51