Toyota 1986 Landcuiser Repair Manual page 136

TF·26
it ' ACI"~~'
Ad"", . F"",C,,,
e
Trander
~
' .... 0
~
,-
TRANSFER - Transfer
6. INSTALL ADJUSTING SHIM TO TRANSFER
FRONT CASE (ATM)
(a) Measure the difference of A and B (left), and select a
shim of a thickness
so
the gap between the transfer
adapter and front case is within the standard clear·
Standard clearance: 0.4 - 0 .5 mm (0.016 - 0.020 in.)
Adjuni"i lhim thick"," mm (in.)
2.28 - 2.32 (0.0898 - 0.0913)
2.38 - 2.42 (0.0931 - 0.0953)
2.48-2.52 (0.0916-0.09921
(b) Install the adjusting shim to the transfer front case.
7.
INSTALL TRANSFER FRONT CASE
(a) Apply MP grease to the oil seal.
8.
Ib) Install the front case with a new gasket to the transfer
adapter.
(c) Apply liquid sealer to the bolts, and install and
torque as shown.
4·Speed: Four bolts
5·Speed: Three bolts
Torque : 17 mm 650 kg-cm 147 ft·lb, 64 N·m)
14 mm 400 kll-cm 129 ft·lb, 39 N·m)
Id) Install and torque the other bolts.
Torque : 650 kll-cm (47 ft·lb,
64
N·m)
INSTALL SHIFT FORK SHAFT
[Mechanical Shift Type]
(a) Install the shift fork shaft into shift fork No. 1.
Ib) Using a pin punch and a hammer, drive in the slotted
spring pin.
NOTE: Use a set of soft jaws in the vise to protect the
shift fork.
[ Electrical Shift Type]
(a) Using snap ring pliers, install the snap ring.