Toyota 1986 Landcuiser Repair Manual page 140

22. ADJUST REAR OUTPUT SHAFT PRELOAD
(a) Install the rear output shaft rear bearing retainer.
NOTE : Align the bearing retainer rib with the case.
(b) Torque the six bolts.
Torque: 350 kg-cm (25 ft -Ib, 34 N'm)
(c) Shift the transfer lever to the "N" position.
(d) Temporarily install the rear companion flange lock
nut.
(e) Using a torq ue meter, measure the rear output shaft
preload. (Starting torque)
Preload :
New bearing 15 - 24 .7 kg-c:m
(13.0 - 21.4 in..tb, 1.5 - 2.4 N'm)
Reused bearing 7 - 12 kg-cm
(6.1 - 10.4 in.-Ib, 0.7 - 1.2 N'm)
If the preload is not within specification, remove the outer
race of the rear output shaft rear bearing with SST.
SST 09514-35011
Reselect an adjusting shim.
M. rk
Thieknus mm (in.) Mark T hicknell
mmi in.)
0
0. 15 (0.0059)
10 1.0 (0.039)
.
0.'
(0.016)
11
..,
(0.043)
5
0.5 {0.0201
12
'.2
(0.047)
6
0.6
10.0241 13 1.3 (0.051)
,
0.'
(0.028)
"
' A
(0.055)
6
0.'
(O.03t)
15 ' .5
(0. 059)
9
0.9 (0.035)
NOTE : The preload will change about 10.0 kg-c:m (8.7
in.·lb, 1.0 N·m) with each shim thickness.
(f)
Remove the rear companion flange lock nut.