Table of Contents
Advertisement
The setting shows briefly, then
4
disappears automatically.
70
Adjusting the chassis and
suspension
Switching on ignition (
z
Press button 1 briefly to view
the current setting.
To adjust damping:
Repeatedly press button 1 until
the setting you want to use
appears on the display.
You can adjust the damping
characteristic while the mo-
torcycle is on the move.
The following settings are avail-
able:
SOFT
: Comfortable damping
characteristic
NORMAL
: Normal damping
44).
characteristic
HARD
: Sporty damping char-
acteristic
with Pro riding modes
In the ENDURO and ENDURO
PRO modes, only two settings
are possible:
SOFT
: Comfortable damping
characteristic
HARD
: Sporty damping char-
acteristic
To adjust spring preload:
Start engine (
Repeatedly press button 1 and
hold until the setting you want
to use appears on the display.
You cannot adjust spring
preload while the motor-
cycle is on the move.
The following settings are avail-
able:
OE
Wait for the mechanism to
complete all adjustments be-
fore you ride off.
The settings for damping and
spring preload shown on the
display are automatically ac-
cepted if you allow a certain
length of time to pass without
pressing button 1. The ESA
82).
indicator flashes while adjust-
ment is in progress.
If the temperature is very low,
take the weight off the motor-
cycle before increasing spring
preload; if applicable, have your
passenger dismount.
One-up
One-up with luggage
Two-up (with luggage)
Advertisement
Table of Contents
