Bosch 7 620 320 029 Operating Instructions Manual page 18

18 | en
PIN entry
f
Change the PIN of the inserted SIM card here. Have
the current PIN ready before you start.
Data volumes
f
Display the time at which the data volume counter
was last reset to "0".
The data volume for uploads and downloads since
the last reset is shown on the status line at the
bottom left.
Click Reset counter to reset the counter.
User / Password
f
If your provider requires it, enter the username and
password for the mobile internet connection here.
Authentication
f
If the username and password are necessary, enter
the authentication mode (PAP, CHAP) here.
f DNS1/2
If DNS server names are not assigned automatically,
enter them here.
WLAN settings
f Choose the Settings/WLAN menu item.
You will find these settings in the WLAN menu:
f SSID (network name)
The SSID (Service Set Identifier) is the network
name of the device in the WLAN, and is factory-set
to "Coach MediaRouter".
You can enter an individual network name of up to
32 characters in length.
Hide SSID
f
When this option is switched on, the WLAN network
of the device is invisible to other WLAN devices.
7 620 320 029 | 09.2014
Network mode
f
Choose the WLAN standard you want here (Mixed
b/g/n / Mixed b/g / b-only / g-only / n-only).
Region
f
Choose the region in which you will use the device
here. The number of available channels (see next
point) differs between regions.
f Channel
Choose the channel that the device is to use in the
wireless network here. The set channel determines
the frequency on which the device will send and
receive.
Encryption
f
Choose the encryption method that will be used for
the data traffic between the WLAN and the device
here (WPA / WPA2 / WPA & WPA2 mixed), or else
turn encryption off (Open). Encrypted data traffic
prevents unauthorized access to the data being
exchanged.
Network key / Re-enter key
f
The WLAN data traffic (see previous point) is
encrypted with the help of the key. The key must be
supplied by the end device when establishing the
WLAN connection. The factory-set key is given on
the underneath of the device.
You can enter an individual key of up to 63 charac-
ters in length.
IP
f
Enter the network address (IP address) that allows
access to the device or to its user interface here.
The factory setting for the IP address of the device
is:
192.168.1.1
Subnet mask
f
Enter the subnet mask for the WLAN network of the
device here.
The subnet mask specifies what range of IP
addresses is available for end devices in the WLAN
network of the device.
The factory setting for the subnet mask of the
device is: 255.255.255.0
Robert Bosch Car Multimedia GmbH
Settings