E) Connections For The 15 Pin D Sub Connector - Omega 3200 User Manual

e) Connections For The 15 D Sub Connector
Using a suitable mating connector the pins of the integrated connector
should be wired as follows:
Connecting To The Integrated 15 Pin Connector
PIN 7 should be connected to the Positive of the power source.
PIN 5 should be connected to the Negative ( Ground ) of the power
source.
PIN 2 provides the signal output and should be connected to the positive
terminal of the display, data acquisition system or voltmeter.
PIN 10 is the signal negative (ground) and should be connected to the
negative (Ground) terminal of the display, data acquisition system or
voltmeter.
Pin 8 is the input signal and should be connected to the positive terminal
of the voltage source. The (0-5VDC) voltage control signal should be
supplied from a low impedance source.
Pin 1 is the input signal negative (ground) and should be connected to
the negative (Ground) terminal of the voltage source.
Pins 3, 4, 6, 9, 11, 12, 13, 14 and 15 are not used.
Caution: Avoid high voltage static discharges to the input signal
connection. Do not short the output signal pins or allow them to
contact the power connections at any time. DAMAGE WILL
RESULT!
Pin Out of Integrated
Connector
M-4271/0707, pg. 12 of 26