D-Link DSL-2730U User Manual page 50

Section 3 – Web Configuration
IP QoS
Choose ADVANCED > Network Tools> IP QoS. Entries in the QoS Rule List are
used to assign the precedence for each incoming packet based on physical LAN
port, TCP/UDP port number, source IP address, destination IP address and other
information.
UPnP
Choose ADVANCED > Network Tools > UPnP. The page shown in the figure
appears on the right. This page is used to configure UPnP. The system acts as a
daemon after you enable it.
SNMP
Choose ADVANCED > Network Tools > SNMP. The page shown in the figure
appears on the right. You can configure the SNMP parameters.
The following table describes the parameters of this page:
Field
Enable SNMP
Trap IP Address
Community Name
(Read-only)
D-Link DSL-2730U User Manual
Description
Select it to enable SNMP function. You need to
enable SNMP, and then you can configure the
parameters of this page.
Enter the trap IP address. The trap information is
sent to the corresponding host.
The network administrators must use this password
to read the information of this router.
48