Wireless Setup - D-Link DSL-2730U User Manual

Section 3 – Web Configuration

Wireless Setup

Wireless Basics
Choose SETUP > Wireless Setup> Wireless Basics. The page is shown as the
figure appears on the right. In this page, you can configure the wireless settings for
your router.
The following table describes the parameters of this page:
Field
Choose the adapted band of the modem from the
drop-down list.
Band
Set the working mode of the device. The mode may vary
Mode from software to software. By default, the network mode
of the modem is AP.
Set a name for the wireless network of your device.
SSID Wireless stations associating to the modem must have
the same SSID.
A channel is the radio frequency used by 802.11b/g/n
wireless devices. You may have a choice of channels (for
your region) and you should use a different channel from
Channel
an adjacent AP to reduce the interference. Interference
Number
and degrading performance occurs when radio signal
from different APs overlap.
Choose a channel from the drop-down list box.
Choose the transmission power of the radio signal. It is
Radio Power
recommended to leave the default setting. The default
D-Link DSL-2730U User Manual
Description
29