D-Link DSL-2730U User Manual page 30

Section 3 – Web Configuration
DHCP Server
-
DHCP Server: If you are using 2730U as a DHCP server, select DHCP Server.
The 2730U will assign IP address to the hosts connected to the 2730U.
Step 1 Select DHCP Server from the DHCP Mode.
Step 2 Select interfaces using the DHCP Mode set in Step 1.
Step 3 Set the IP pool range. It specifies the first IP address in the IP address
pool. The router assigns IP address that base on the IP pool range to
the host. You can keep it as defaults.
Step 4 Set the default gateway. You can keep it as defaults: 192.168.1.1.
Step 5 Set the Max lease time. The lease time determines the period that the
host retains the assigned IP addresses before the IP addresses
change.
Step 6 Set the Domain Name and DNS Servers. You can keep it as defaults.
Step 7 After setting, click Apply Changes to save the settings.
DHCP Relay
-
DHCP Relay: If you are using the other DHCP server to assign IP address to
your hosts on the LAN, enable the DHCP Relay. You can set the DHCP server IP
address. The DHCP Relay enables the message to transmit between clients in
different network segment.
Step 1 Select DHCP Relay from the DHCP Mode.
Step 2 Set the Relay Server. You can keep it as defaults.
Step 3 After setting, click Apply Changes to save the settings.
DHCP Reserved
Choose SETUP > Local Network > DHCP Reserved. The page shown in the
right figure appears. This page allows you to reserve IP address for PC specified
in this page.
D-Link DSL-2730U User Manual 28