Assembly Instructions - Kärcher HD 3.0/27 G Operator's Manual

Safety
Latch
High
Pressure Hose
STEP 1: Attach the high pressure
hose to the spray gun using tefl on
tape on hose threads.
Pressure
Nozzle
Coupler
Collar
STEP 4: Release the coupler collar
and push the nozzle until the collar
clicks. Pull the nozzle to make sure
it is seated properly.
Garden
Hose
STEP 7: Check inlets fi lters, re-
move debris, then connect the
garden hose to pump water inlet.
CAUTION: Do not run the pump
without water or pump damage
will result.
STEPS 8 and 9 for Electric Start Machines Only
Battery
Terminal
12 Volt
Battery
Battery Box
8

ASSEMBLY INSTRUCTIONS

Spray
Gun
Wand
STEP 2: Attach wand to spray gun
using tefl on tape on wand threads.
Wand
Coupler
High
Pressure
Hose
STEP 5: Connect the high pressure
hose to the discharge nipple. Push
coupler collar forward until secure.
Pump
Water Inlet
Battery
Box Lid
Black Wire From
ground
Red Wire From the
motor starter
Box Strap
• 9.801-759.0 • Rev. 11/15
Spray
Gun/Wand
Discharge
Nipple
Coupler Collar
( HD 4.0/40 Ge and HD 4.0/40 GeB)
STEP 8: Place battery in bat tery box. Use a standard
12 volt bat tery.
STEP 9: To reduce the pos si bil i ty of spark ing attach the
wires to the battery in the fol low ing order.Refere to
image aside. First attach the red wire to the positive "+"
terminal of battery and the black wire to the negative
"-" terminal of the battery.To dis con nect the battery
remove the wires in the op po site order as installed.
Install bat tery box cover and fasten in place.
Pressure
Nozzle
Wand
Coupler
STEP 3: Pull spring-loaded collar
of the wand coupler back to insert
your choice of pressure nozzle.
Cold
Water
Source
Garden
Hose
STEP 6: Connect garden hose to
the cold water source.