Table of Contents
Advertisement
INSTALLATION
2
Quick Instructions
Install the unit (1U high, 19" wide) to the installation
1
cabinet. A 12 V supply voltage is provided by a CPS23x
mains adapter.
Switch on the system power and see that the "M", "C"
and "V" -indicators on the front panel of the unit are lit.
2
The "M" (=module) should lit green to show that
hardware is operating properly.
Connect all needed audio/data signals to their
3
respective connectors on the unit's front panel.
Connect a monitor to either CVBS video output (BNC)
4
or S-VIDEO output (mini-DIN). These signals are both
constantly available.
Connect the ATM network to port "ATM" in the
5
front panel.
Connect a PC (with the Commander software installed)
6
to the Control Bus using the DVX021 connection cable.
Start Commander and select the unit to confi gure and
proceed by fi lling in the required parameters.
7
Alternatively, if the in-band management is operational
over the ATM network, this can be done remotely from a
control center.
Make sure that the unit is not indicating any alarms or
8
warnings (Status page). The "M", "C" and "V" -indicators
on the front panel should now lit green.
IND2x2 Series User Manual rev001
Advertisement
Table of Contents
