Installation - Teleste MCC101 User Manual

2. Installation

Connecting Video
Encoder System

Connect the camera video output (analogue composite video) to the encoder video input port.
Decoder System

Connect a monitor to the video output (analogue composite video) port accordingly.
Connecting Audio
Audio is full-duplex. Alternative operation modes are Tx-only, Rx-only or Tx-Rx.
Connect audio input and output ports to the audio devices accordingly.

Audio signal provided on a line level (+4 dBu), so audio equipment with an amp, mixer or other amplifier

should be used.
Connecting Serial Ports
For camera control, a PTZ controller (keyboard) and a receiver can be connected to the serial ports. Two
corresponding serial ports in encoder and decoder which are connected in 1-to-1 fashion works as in pass-
through mode. This means that commands at a local system's COM1 port will be transparently passed to the
remote system's COM1 port. Also, a command at a local system COM2 port will pass to the remote system's
COM2 port.
Connecting Sensor and Alarm
Connect sensor and alarm devices to corresponding terminals accordingly.
Connecting Power
After confirming the proper power source, connect the mains adaptor to the AC line and connect the 12VDC
connector to the MCC unit.
8 • 2. Installation
MCC101 User manual