Teleste EASI ATM IND2x2 Series User Manual page 26

Picture 20.
Commander's "Modify (ATM)
Interface" view.
Picture 21.
Commander's "Add/Modify IP
Route" view.
24
How to modify ATM Interface
Select the ATM interface from the Interface list (see picture 19
and click modify
"Modify Interface" window appears on the screen (see picture
20). Set required values to IP address, Subnet mask and
hardware address fi elds and click
the ATM interface by ticking the checkbox "Enabled".
How to add/modify IP Route
Click Add to add new IP Route or select the IP Route
from the IP Routes Interface list (see picture 19). Click
to modify IP Route. The following "Add/Modify IP Route"
window appears on the screen (see picture 21). Set required
values to Network Destination, Subnet mask and Gateway
fi elds and click OK
DVX Busmaster checkbox
Not used.
Aal5 crc32 check checkbox
ATM checksum calculation, normally not used.
All changes in settings should be confi rmed by
pressing Apply .
to modify ATM interface. The following
OK
to continue.
IND2x2 Series User Manual rev001
to continue. Enable
modify