Marantz SR6006 Getting Started page 39

STEP 5
Check
12
Use ui to select the item you
want to check, and then press
ENTER .
AUDYSSEY AUTO SETUP
1 2 3 4 5 6
STEP5 Check
Check processing results.
To proceed, press "Next".
Speaker Config. Check
Distance Check
Channel Level Check
Crossover Freq. Check
Next Store
Enter Cancel
RETURN
Proceed to next (Store)
• Subwoofers may measure a greater reported distance than
the actual distance due to added electrical delay common in
subwoofers.
RETURN
• If you want to check another item, press
13
i
Use to select "Next → Store" and then press
ENTER
.
NOTE
• If the result differs from the actual connection status, or if "Caution!"
is displayed, see "Error messages" (vpage
Audyssey ® Auto Setup again.
• If you change speaker positions or orientation, perform Audyssey ®
Auto Setup again to find the optimal equalizer settings.
STEP 6
Store
14
Select "Store" and then press
Save the measurement results.
STEP6 Store
Press "Store" to store calculation results.
Store
Apply and store measurement result
STEP6 Store
Now storing...Please wait.
20%
.
• Saving the results requires about 10 seconds.
• If the measuring results are not to be saved, press
25). Then carry out message "Cancel auto setup?" will be displayed. Press o then
select "Yes". All the measured Audyssey ® Auto Setup data will
be erased.
• During saving of measurements results, "Now storing...Please
wait." is displayed. When saving is completed, "Storing complete.
Auto Setup is now finished." is displayed.
NOTE
During saving of measurement results, be sure not to turn off the
power.
ENTER
.
AUDYSSEY AUTO SETUP
1 2 3 4 5 6
Enter Cancel
RETURN
AUDYSSEY AUTO SETUP
1 2 3 4 5 6
RETURN
. A
24
Set up speakers (Audyssey ® Auto Setup)
Finish
15
Unplug the setup microphone from the unit's SETUP
MIC jack.
16
Set Audyssey Dynamic Volume ® .
AUDYSSEY AUTO SETUP
Finish 1 2 3 4 5 6
Storing complete.
Auto Setup is now finished.
Please unplug microphone.
Turn on Dynamic Volume?
Yes
No
Exit
Turn Dynamic Volume off and exit Auto Setup
• This feature adjusts the output volume to the optimal level while
constantly monitoring the level of the audio input to the unit.
Optimal volume control is performed automatically without any
loss in the dynamism and clarity of the sound when, for example,
the volume suddenly increases for commercials shown during
television programs.
n When turning Dynamic Volume ® on
ENTER
• Use u to select "Yes", and then press
The unit automatically enters "Medium" mode.
n When turning Dynamic Volume ® off
ENTER
• Use i to select "No", and then press
NOTE
After performing Audyssey ® Auto Setup, do not change the speaker
connections or subwoofer volume. In event of a change, perform
Audyssey ® Auto Setup again.
.
.