Marantz SR6006 Getting Started page 164

Symptom
Cannot compile • This unit does not respond to playlist compilation. When the
Playlist. playlist is compiled in PC Application, it is registered to "My
Library". In this way, the playlist can be played in this unit
Cannot delete • Cannot be done with this unit. Delete from PC Application.
Rhapsody Channel
registered in "My
Channels".
Cannot delete • Cannot be done with this unit. Delete from PC Application.
Tracks, Playlists,
Channels registered
in "My Library"
Cannot login to • Login information is incorrect. Check if the Username for Napster
Napster. ("Incorrect has been properly entered. Re-enter the Password. (Password is
Username or not displayed.)
Password" is http://www.napster.com/choose/index_default.html
displayed.)
Cannot login to • Login information is incorrect. Check if the "Email address" for
Pandora. ("Email Pandora has been properly entered. Re-enter the "Password".
address" or (Password is not displayed.)
"Password" is http://www.pandora.com/marantz
displayed.)
Cause/Solution
GAirPlayH
Page
Symptom
–
The AirPlay icon • This unit and the computer or iPhone/iPod touch/iPad are not
is not displayed connected to the same network (LAN). Connect the computer or
in iTunes or on the iPhone/iPod touch/iPad to the same network as this unit.
–
iPhone/iPod touch/ • iTunes or the iPhone/iPod touch/iPad do not have firmware that
iPad. supports AirPlay installed. Update to the latest firmware.
No sound. • The volume in iTunes or on the iPhone/iPod touch/iPad is set to
the minimum setting. Adjust the volume to the optimum level.
–
• This unit is not selected in the screen that is displayed when
iTunes or the iPhone/iPod touch/iPad is started. Start iTunes or
switch on the iPhone/iPod touch/iPad, click the AirPlay icon
the displayed screen, and select this unit.
47, 115
GM-XPortH
Symptom
Audio is not output • Check that the Bluetooth device and Wireless receiver (RX101)
when a wireless are correctly paired.
49
receiver (RX101 is
connected).
GRemote Control UnitH
Symptom
The set cannot be • Batteries are worn out. Replace with new batteries.
operated with the • Operate the remote control unit within a distance of about
remote control unit. 23 ft/7 m from this unit and at an angle of within 30°.
• Remove any obstacle between this unit and the remote control
unit.
• Insert the batteries in the proper direction, checking the q and
w marks.
• The set's remote control sensor is exposed to strong light (direct
sunlight, inverter type fluorescent bulb light, etc.). Move the set
to a place in which the remote control sensor will not be exposed
to strong light.
• The operation mode does not match the settings of the device to
operate. Check the operation mode.
149
Cause/Solution
in
Cause/Solution
Cause/Solution
Page
19
119
–
76
Page
17, 145
Page
135
135
135
135
135
123