Marantz SR6006 Getting Started page 38

STEP 3
Measurement (2nd – 8th)
• In STEP 3, you will perform measurements at multiple positions (two
to eight positions) other than the main listening position.
• Just one position can be measured but measuring multiple positions
increases the accuracy of the correction of acoustic distortion within
the listening area.
9
Move the setup microphone to
position 2, use ui to select
"Measure", and then press
ENTER .
The measurement of the second
position starts. Measurements can be
made in up to eight positions.
AUDYSSEY AUTO SETUP
1 2 3 4 5 6
STEP3 Measurement (2nd)
Please place the microphone at ear
height at 2nd Iistening position.
Measure
Next Calculation
Enter Cancel
RETURN
Start measurement. Output large test tone during measuring
If you want to omit measurements from the next position onward,
select "Next Calculation".
(Go to STEP4 Calculation
)
10
Repeat step 9, measuring positions 3 to 8.
When measurement of position
"Measurements finished." message is displayed.
AUDYSSEY AUTO SETUP
STEP3 Measurement (Finish) 1 2 3 4 5 6
Measurements finished.
Retry
Next Calculation
Enter Cancel
RETURN
Proceed to next (Calculation)
23
STEP 4
Calculation
11
On the
STEP 3
8 is completed, a
Calculation", and then press
Measuring results are analyzed, and the frequency response of
each speaker in the listening room is determined.
STEP4 Calculation
Now calculating...Please wait.
20%
• Analysis takes several minutes to complete. The time required for
this analysis depends on the number of speakers connected.
The more connected speakers there are, the longer it takes to
perform analysis.
Set up speakers (Audyssey ® Auto Setup)
screen, use ui to select "Next →
ENTER
.
AUDYSSEY AUTO SETUP
1 2 3 4 5 6
vSee overleaf