Control For Hdmi - Sony DAV-DZ310 Operating Instructions Manual

Audio track/file transfer
Symptom
You cannot start transferring
onto a USB device.
Transferring stops before it is
finished.
Transferring to a USB device
results in an error.
Audio files or folders on the
USB device cannot be erased.
Tuner
Symptom
Radio stations cannot be tuned
in.
FM reception is poor.

Control for HDMI

Symptom
The Control for HDMI function
does not work.
No sound is output from the
system and TV while using the
System Audio Control function.
Downloaded From TheatreSystem-Manual.com Manuals
Problems and solutions
• The following problems may have occurred.
– The USB device is full.
– The number of audio files and folders on the USB device has reached the
upper limit.
– The USB device is write-protected.
• The communication speed of the USB device is extremely slow. Connect a
USB device that this system can play.
• If the transferring and erasing operations are repeated multiple times, the file
structure within the USB device becomes complex. Follow the procedure in the
operating instructions of the USB device to format the USB device. If the
problem persists, contact your nearest Sony dealer.
• The USB device is full.
• The number of audio files and folders on the USB device has reached the upper
limit.
• The USB device was disconnected or the power was turned off during erasing.
Delete the partially-erased file. If this does not fix the problem, the USB device
may be broken. Follow the procedure in the operating instructions of the USB
device to format the USB device. If the problem persists, contact your nearest
Sony dealer.
• Check if the USB device is write-protected.
Problems and solutions
• Check that the antenna (aerial) is connected securely. Adjust the antenna
(aerial) or connect an external antenna (aerial) if necessary.
• The signal strength of the stations is too weak (when tuning in with automatic
tuning). Use direct tuning.
• Use a 75-ohm coaxial cable (not supplied) to connect the unit to an outdoor FM
antenna (aerial).
Problems and solutions
• Set [CONTROL FOR HDMI] in [HDMI SETUP] to [ON] (page 63).
• Make sure that the connected component is compatible with the [CONTROL
FOR HDMI] function.
• Check the connected component's setting for the Control for HDMI function.
Refer to the operating instructions of the component.
• If you change the HDMI connection, connect and disconnect the AC power
cord (mains lead), or have a power failure, set [CONTROL FOR HDMI] in
[HDMI SETUP] to [OFF], then set to [ON] (page 63).
• For details, see "Using the Control for HDMI Function for "BRAVIA" Sync"
(page 53).
• Make sure that the connected TV is compatible with the System Audio Control
function.
• For details, see "Using the Control for HDMI Function for "BRAVIA" Sync"
(page 53).
75
GB