Sony DAV-DZ310 Operating Instructions Manual page 68

[SUBWOOFER]
[YES]
Note
• When you change the [CONNECTION] setting, the
[STANDARD] of [SPEAKER FORMATION]
setting remains the same, but the other settings of
[SPEAKER FORMATION] return to
[STANDARD].
x [DISTANCE (FRONT)]
Set the distance of the front and center speakers
from the listening position.
For the best possible surround sound, place all
speakers at the same distance from the listening
position. The distance can be between 1.0 to 7.0
1)
meters (3 to 23 ft) for the front speakers, and
0.0 to 7.0 meters
speaker.
If you cannot place the center speaker at the
same distance, you can move the center speaker
up to 1.6 meters closer to the listening position.
[L/R] 3.0 m/10 ft: Set the front speaker distance.
[CENTER] 3.0 m/10 ft: Set the center speaker
distance.
1)
0.9 to 6.9 meters for North American models.
2)
0.0 to 6.9 meters for North American models.
x [DISTANCE (SURROUND)]
Set the distance for the surround speakers from
the listening position.
For the best possible surround sound, place all
speakers at the same distance from the listening
position. The distance can be between 1.0 to 7.0
meters* (0 to 23 ft).
If you cannot place surround speakers at the
same distance, you can move the surround
speakers up to 5.0 meters (16 ft) closer to the
listening position.
[L/R] 3.0 m/10 ft: Set the surround speaker
distance.
* 0.0 to 6.9 meters for North American models.
Note
• Depending on the input stream, the [DISTANCE]
setting may not be effective.
68
GB
Downloaded From TheatreSystem-Manual.com Manuals
2)
(0 to 23 ft) for the center
x [LEVEL (FRONT)]
You can adjust the sound level of the front
speakers, center speaker, and subwoofer. You
can set the parameters from –6.0 dB to 0 dB for
[L/R], and from –6.0 dB to +6.0 dB for
[CENTER] and [SUBWOOFER]. Be sure to set
[TEST TONE] to [ON] for easy adjustment.
[L/R] 0.0 dB: Set the front speaker level.
[CENTER] 0.0 dB: Set the center speaker level.
[SUBWOOFER] +2.0 dB: Set the subwoofer
level.
x [LEVEL (SURROUND)]
You can adjust the sound level of the surround
speakers. You can set the parameter from –6.0
dB to +6.0 dB. Set [TEST TONE] to [ON] for
easy adjustment.
[L/R] 0.0 dB: Set the surround speaker level.
x [TEST TONE]
You can adjust the sound level of the speakers
by using the [TEST TONE] function.
[OFF]: The test tone is not emitted from the
speakers.
[ON]: The test tone is emitted from each speaker
in sequence while adjusting the level.
Adjust the sound level as follows.
1
Set the [TEST TONE] to [ON].
2
Press C/X/x/c repeatedly to select the
desired speaker and the level, then
press .
3
Repeat Step 2.
4
Press C/X/x/c to set [TEST TONE] to
[OFF] after adjusting the speaker level.