Panasonic WV-SBV131M Operating Instructions Manual page 76

11 Configure the settings relating to images [Image]
[Refresh interval]
Select an interval (I-frame interval; 0.2 - 5 seconds) to refresh the displayed H.264 images.
If using under a network environment with frequent error occurrences, shorten the refresh interval for H.264
to diminish image distortions. However, the refresh interval may be longer than the set value.
0.2s/ 0.25s/ 0.33s/ 0.5s/ 1s/ 2s/ 3s/ 4s/ 5s
•
Default: 1s
[Transmission type]
Select the transmission type of H.264 images from the following.
•
Unicast port (AUTO): Up to 14 users can access a single camera concurrently. "Unicast port" when
transmitting images from the camera. When it is unnecessary to fix the port number for H.264 image
transmission such as when using in a particular LAN environment, it is recommended to select "Unicast
port (AUTO)".
•
Unicast port (MANUAL): Up to 14 users can access a single camera concurrently. It is necessary to select
"Unicast port" manually to transmit images from the camera.
It is possible to fix the port number of the router used for H.264 image transmission via the Internet by
setting "Unicast port (MANUAL)" (®page 121). Refer to the operating instructions of the router in use.
•
Multicast: Unlimited number of users can access a single camera concurrently. Complete the entry field
of "Multicast address", "Multicast port" and "Multicast TTL/HOPLimit" when transmitting H.264 images with
multicast. Refer to page 7 for further information about the maximum concurrent access number.
•
Default: Unicast port (AUTO)
[Unicast port]
*1
Enter the unicast port number (used to transmit images from the camera).
•
Available port number: 1024 - 50000 (Only even numbers are available.)
•
Default:
–
H.264(1): 32004
–
H.264(2): 32014
–
H.264(3): 32024
–
H.264(4): 32034
[Multicast address]
Enter the multicast IP address. Images will be transmitted to the designated IP address.
•
Available IPv4 address: 224.0.0.0 - 239.255.255.255
•
Available IPv6 address: Multicast address starting with "FF"
•
Default:
–
H.264(1): 239.192.0.20
–
H.264(2): 239.192.0.21
–
H.264(3): 239.192.0.22
–
H.264(4): 239.192.0.23
Note
•
Enter a multicast IP address after checking available multicast address.
[Multicast port]
*2
Enter the multicast port number (used to transmit images from the camera).
•
Available port number: 1024 - 50000 (Only even numbers are available.)
•
Default: 37004
[Multicast TTL/HOPLimit]
Enter a value for "Multicast TTL/HOPLimit".
•
Available value: 1-254
76 Operating Instructions
*2
*2