Turning On The Monitor - HP LP2480zx User Manual

4. Pivot the monitor clockwise from landscape to portrait orientation viewing to adapt to your
application.
CAUTION:
with the desk or table top surface when rotating the display panel to the portrait position. Ensure
that there is enough clearance for the USB cables as you rotate the monitor.
Be sure to remove any cables from the cable management opening before pivoting the monitor.
Figure 3-9
NOTE:
Assistant software included on the software and documentation CD. The position of the OSD menu
can also be rotated to portrait mode. To rotate the OSD menu, press the Menu button on the
monitor's front panel, then select OSD Control > OSD Rotation.
CAUTION:
result in damage to the monitor.

Turning on the Monitor

1. Press the power switch to turn on the computer.
2. Verify the master power switch on the rear of the monitor is in the on (I) position.
3. Press the power button on the front of the monitor.
CAUTION:
screen for a prolonged period of time.* To avoid burn-in image damage on the monitor screen, you
should always activate a screen saver application or turn off the monitor when it is not in use for a
prolonged period of time. Image retention is a condition that may occur on all LCD screens.
* A prolonged period of time is 12 consecutive hours of non-use.
NOTE: After turning on the monitor, a minimum 30 minute warm-up time is required for best
performance.
14 Chapter 3 Setting Up the Monitor
Downloaded from ManualMonitor.com Manuals
USB cables that are connected to the monitor can be damaged if they come in contact
Pivoting the Monitor
To view information on the screen in portrait mode, you will need to install the HP Display
Monitor display panel orientations of 180 and 270 degrees are not supported and may
Burn-in image damage may occur on monitors that display the same static image on