Hinge Cover - Dell Latitude D820 User Manual

1. If present, remove the device security screw from the bottom of the computer (see
2. If the computer is running, double-click the Safely Remove Hardware icon on the taskbar, click the device you want to eject, and click Stop.
3. Press the device latch release.
4. Pull the device out of the media bay.
5. Push the new device into the bay until it clicks.
Hinge Cover
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as a connector on the back of the computer).
NOTICE: The hinge cover is fragile and can be damaged if extreme force is used. Be careful when removing the hinge cover.
1. Follow the procedures in
2. Turn the computer top-side up, and then open the display all the way (180 degrees) so that it rests on your work surface.
NOTICE: To avoid damaging the hinge cover, do not lift the cover on both sides simultaneously.
3. Insert a scribe in the indent to carefully pry up the hinge cover on the right side.
1

hinge cover

4. Ease the hinge cover up, moving from right to left, and remove it.
5. To replace the hinge cover, insert the left edge of the cover into the hinge cover slot, and press from left to right until the cover snaps into place.
Downloaded from LpManual.com Manuals
Before You Begin.
2 indent
Removing the Device Security Screw).