Olympus Stylus 500 Advanced Manual page 61

TIPS
The self-timer/remote control lamp does not blink after the shutter button
on the remote control device is pressed.
→ The remote control device may be too far from the camera. Move closer to
the camera and press the shutter button on the remote control device again.
To operate the zoom from the remote control device.
→ Aim the remote control device at the receiver on the camera and press the
W or T button on the remote control device.
How to cancel the remote control mode.
→ The remote control mode is not canceled automatically after shooting. Go
to Step 2 and set the mode to [Z OFF].
Note
• The camera does not correspond to the switching channel function of the
remote control device. The camera will receive the remote control signal with
either channel.
• If the remote control receiver is exposed to strong light, the effective signal
distance may be reduced or shooting may not take place.
• To shoot sequential shots using the remote control device, press and hold the
shutter button on the remote control device. If the camera does not receive the
remote control signal properly, sequential shooting may stop.
• To view pictures using the remote control device, refer to the instruction manual
for the remote control device.
Remote control shooting (optional)
5
61