Check Before Installing; Before Using The Product; Important To Installer; Location Considerations - Samsung SDC1A809 User Manual

Condensing dryer
Hide thumbs Also See for SDC1A809:
Table of Contents

Advertisement

installing your dryer

CHECK BEFORE INSTALLING

Do not plug the power cord into the wall outlet before completing the dryer installation.
Check the appearance of the product for any damaged parts before starting the product installation.
If there are any parts that appear to be damaged, please contact your nearest Samsung Customer
Service Center.
When moving the product, do not move the product by yourself.
Take care of the edges of the dryer as they can be sharp.
Do not install the dryer in a location exposed to frost. Cold water may damage the product.
Use the product indoors only.
Do not place the dryer on one side when lifting it, and do not move the dryer in such a way that the
internal parts shake. This may result in damage to the internal parts of the product.

BEFORE USING THE PRODUCT

Check if there are any accessories remaining inside the drum.
Plug in the power cord just before operating the product.
Do not block the air inlet hole of the cooling grill at the front of the dryer.
Do not place inflammable objects near the dryer and keep the surroundings clean.
Keep the dryer level with the ground.
Do not remove the adjustable levelling feet of the dryer. They are necessary to keep the product level
with the ground.

IMPORTANT TO INSTALLER

Please read the following instructions carefully before installing the dryer. These instructions should be kept
for future reference.
REMOVE THE DOOR FROM ALL DISCARDED APPLIANCES TO AVOID THE DANGER OF A CHILD
WARNING
SUFFOCATING.

LOCATION CONSIDERATIONS

Because a condensing type has been adopted, which condenses and processes air inside the dryer,
external ventilation is not required.
Therefore, The dryer can be installed and used in any location where the temperature is between 5
and 35 degrees centigrade, unlike a conventional dryer that requires an external exhaust system.

ALCOVE OR CLOSET INSTALLATION

To operate safely and properly, your new Dryer requires minimum clearances of:
Sides – 25 mm
Top – 25 mm
If both the washing machine and a dryer are installed together, the front of the alcove or closet must have at
least 465 mm unobstructed air opening.
SDC1A809-02805J-05_EN_140507.indd Sec3:10
SDC1A809-02805J-05_EN_140507.indd Sec3:10
Rear – 51 mm
Front – 465 mm
English - 10
2014-05-07
2014-05-07
6:29:45
6:29:45

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sdc3k801

Table of Contents