Master Section - Wharfedale Pro R1604 Operating Manual

R Series Mixers

Master Section

AUX sends
18. AUX 1 & 2 Control: The AUX1,2 master VR provide
over all level control of AUX send.
19. AUX Send Jacks: These unbalanced 1/4 jacks are
AUX1 and AUX 2 outputs.
Stereo EFX Returns
20. EFX Return Jacks
There are two additional Stereo AUX returns on the
R1604/2004. The EFX Return act as mini Input
Channels and are used to bring signals from Effect Unit
back to the mixer via the EFX Return inputs on the top
panel. When using an Effect Unit with stereo outputs the
left and right EFX Return inputs can be used to keep the
stereo effect. The outputs of the Effect Unit should be
plugged into the corresponding left and right EFX Return
nputs. If you wish to use an EFX Return in MONO then
only the left inputs should be used. This mono signal is
then switched to be sent equally to the left and right Main
outputs. Both EFX Return 1 and EFX Return 2 signal are
assigned to the Main mix, press the EFX TO AUX1(22)
button can route the EFX Return 1 signal to the AUX 1
bus. Press EFX to ALT3-4 (23) button can route the EFX
Return 2 signal to the ALT3-4 output.
21. The EFX Returns levels are operated by these controls.
22. EFX to AUX button. (EFX Return 1)
23. EFX to ALT 3-4. (EFX Return 2)
Metering
24. Level Meter
The level of the Main Mix/Solo is displayed on these 10
segment bargraph meters. When any channels Are
,
SOLO d the Left meter act as the SOLO meter, and are
used to set the correct Input Gain into a channel. If the
signal levels are too high, distortion may result, and if they are too low then unwanted noise will present.
R1604 & R2004
,,
33
21
22
23
18
34
35
38
37
20
.6.
28
27
26
24
25
31
30
36
19 29
32