Starting / Stopping The Engine - Stihl FCS Instruction Manual

Mounting the Loop Handle
9
9
8
8
1
5
6
7
10
10
Place the clamp (5) in the loop
N
handle (1) and position them both
against the drive tube (6).
Place the clamp (7) against the
N
drive tube.
Line up the holes.
N
Fit the washers (8) on the
N
screws (9), and insert the screw in
the holes.
Turn the square nuts (10) as far as
N
stop.
FCS
Adjusting the Loop Handle
A
Align the loop handle (1) and move
N
it to the most comfortable position.
Distance A must not be more than
55 cm (22 in).
Recommendation: distance A:
about 35 cm (14 in)
Tighten down the screws on the
N
loop handle.
Starting / Stopping the
Engine
Starting the Engine
Always follow the starting procedure
described in the basic power tool
instruction manual.
1
Put the unit on the ground: Check
N
that the cutting blade is not touching
the ground or any other obstacles.
Make sure you have a safe and
N
secure footing.
Hold the unit with your left hand and
N
press it firmly against the ground.
NOTICE
Do not stand or kneel on the drive tube.
English
15