Cleaning Your Hard Floors; Cleaning Mode - Bissell CrossWave 1713 SERIES User Manual

Cleaning Your Hard Floors

NOTE: Before you begin, plug the machine into a properly grounded outlet.
1
3
Before each use, hold
the solution spray
trigger for 10 seconds to
prime the system with
cleaning solution. LED
lights illuminate when
holding the trigger.
NOTE: When solution
is flowing, you will see
bubbles forming at the
edges of the brush roll
window.
Select
cleaning
mode:
To start cleaning your
hard floors, turn the
machine ON in the
HARD FLOOR setting.
Once the setting
is selected, the dry
vacuum will turn on.
To turn OFF, press the
HARD FLOOR setting
a second time.
4
To clean, hold the solution
spray trigger to apply
solution on both forward and
backward passes.
NOTE: Hold machine over
stuck on messes while holding
the trigger for best results.
2
Recline the body of the machine
backward to start the brush roll spinning.
To stop the brush roll spinning, you will
need to stand the machine upright.
5
For overly challenging
and stuck-on messes
on your hard floors,
activate the RUG
mode and hold your
CrossWave™ over the
mess.
Using short passes while
holding the trigger
allows the multi-surface
brush to go to work.
www.BISSELL.com
7