Connecting The Switch; Switch To End Node - D-Link DGS-3600 Hardware Installation Manual

Hide thumbs Also See for DGS-3600:

Table of Contents

x Stack

Connecting the Switch

Switch to Hub or Switch

Connecting to Network Backbone or Server

NOTE: All 10/100/1000Mbps NWay Ethernet ports can support both MDI-II and MDI-X con-

nections.

Switch to End Node

End nodes include PCs outfitted with a 10, 100 or 1000 Mbps RJ 45 Ethernet/Fast Ethernet Network Interface Card (NIC) and

most routers. An end node can be connected to the Switch via a twisted-pair Category 3, 4, or 5 UTP/STP cable. The end node

should be connected to any of the ports of the Switch.

The Link/Act LEDs for each UTP port will light green or amber when the link is valid. A blinking LED indicates packet activity

on that port.

DGS-3600 Series Layer 3 M anaged Gigabit Ethernet Sw itch

Figure 3- 1. Switch connected to an end node

Section 3

Table of Contents