Hot-Plug Power Input Module - HP ProLiant ML350 Gen9 Maintenance And Service Manual

Hot-plug power input module

To remove the component:
If only one power input module is installed:
1.
Do the following:
a.
—
For tower models, open and remove the tower bezel (on page 28).
—
For rack models, if installed, remove the security bezel
(optional)" on page 28).
Power down the server (on page 29).
b.
Release the power cords from the strain relief straps.
2.
WARNING: To reduce the risk of personal injury from hot surfaces, allow the power supply or
power supply blank to cool before touching it.
Remove all power:
3.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Remove the power supply.
4.
("Remove the security bezel
Removal and replacement procedures 39