Olympus EVOLT E-330 Advanced Manual page 63

TIPS
The remote control lamp does not blink after the shutter button on the
remote control is pressed
The transmitted signal may not be effective if the remote control receiver is
exposed to powerful lighting. Move the remote control closer to the camera and
press the shutter button on the remote control again.
The transmitted signal may not be effective if the remote control is too far from
the camera. Move the remote control closer to the camera and press the shutter
button on the remote control again.
There is signal interference. Change the channel as described in the remote
control's manual.
To cancel the remote control shooting mode:
The remote control shooting mode will not be canceled after shooting. Set to one
of the other drive modes.
To use the shutter button on the camera in the remote control shooting
mode:
The shutter button on the camera still works even in the remote control shooting
mode.
• The shutter will not be released if the subject is not in focus.
• Under bright light conditions, the remote control lamp may be difficult to see,
making it hard to determine whether or not the picture has been taken.
• Zoom is not available on the remote control.
Bulb shooting on the remote control
Set the mode dial to M, then set the shutter speed to [BULB].
Press the W button on the
remote control to open the
If 8 minutes elapse after
pressing the W button, the
shutter closes
automatically.
x Notes
shutter.
Remote control shooting
Press the T button to close the
shutter.
3
63