Gree GWH18PD-K3NNA1A Service Manual page 21

Notice: This is a general use remote controller, it could be used for the air conditioners with multifunction; For some function, which the
model dosen't have, if press the corresponding button on the remote controller that the unit will keep the original running status.
Remote control
SWING UP AND DOWN BUTTON
Press this button, to set up swing angle,
which circularly changes as below:
This is an universal use remote controller. If
remote controller sends the following three
kinds of status that the swing status of main
unit will be:
When the guide louver start to swing up and
down, if turn off the Swing, the air guide louver
will stop at current position.
Guide for Operation - General Operation
1. After powered on, press ON/OFF button, the unit will start to run. (Note: When it is powered
on, the guide louver of main unit will close automatically.)
2. Press MODE button, select desired running mode.
3. Pressing + or - button, to set the desired temperature. (It is unnecessary to set the temp. at
AUTO mode.)
4. Pressing FAN button, set fan speed, can select AUTO FAN, LOW, MID and HIGH.
5. Pressing button, to select the swing.
18
OFF
which indicates the guide louver swings up
and down between that all five positions.
TIMER ON
TIMER ON BUTTON
Timer On setting: Signal "ON" will blink
and display, signal
numerical section will become the timer
on setting status. During 5 seconds blink,
by pressing ＋ or － button to adjust the
time value of numerical section, every
press of that button, the value will be
increased or decreased 1 minute. Hold
pressing ＋ or －button, 2 seconds later,
it quickly change, the way of change is:
During the initial 2.5 seconds, ten numbers
change in the one place of minute, then
the one place is constant, ten numbers
change in the tens place of minute at 2.5
seconds speed and carry. During 5s blink,
press the Timer button, the timer setting
succeeds. The Timer On has been set up,
repress the timer On button, the Timer
On will be canceled. Before setting the
Timer, please adjust the Clock to the
current actual time.
TIMER OFF
TIMER OFF BUTTON
Once press this key to enter into
TIMER OFF setup, in which case
the TIMER OFF icon will blink.
The method of setting is the same
as for TIMER ON.
Function and Control
will conceal, the