Specifications - Makita HM0830 Instruction Manual

ENGLISH
1. Switch trigger
2. Lock button
3. Side grip
4. Tool retainer
5. Push button

SPECIFICATIONS

Blows per minute
Overall length
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Note: Specifications may differ from country to country.
Symbols
The following show the symbols used for the tool. Be sure
that you understand their meaning before use.
............ Read instruction manual.
............. DOUBLE INSULATION
4
Explanation of general view
6. Hole
7. Commutator
8. Insulating tip
9. Carbon brush
10. Screwdriver
Model
Net weight
Safety class
11. Rear cover
12. Brush holder cap
13. Hex wrench
14. Hex bolts
15. Grease
HM0830
2,700 min
390 mm
Intended use
The tool is intended for chiselling work in concrete, brick,
stone and asphalt as well as for driving and compacting
with appropriate accessories.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated in accordance with European Standard
and can, therefore, also be used from sockets without
earth wire.
-1
4.5 kg
/II