FULL SIZE GAS CONVECTION OVEN - REMOVAL AND REPLACEMENT OF PARTS
BLOWER
electrical power to the machine and
follow lockout / tagout procedures.
Shut off the gas before servicing the
unit.
Removal
1.
Remove racks.
2.
Lay cardboard on bottom of oven cavity to protect
surface.
3.
Remove snorkel (1, Fig. 21) and baffle panel (2,
Fig. 21) mounting screws.
Fig. 21
4.
Loosen set screws on blower hub.
Disconnect the
Page 11 of 35
Fig. 22
5.
Remove blower from motor shaft using a bearing
puller.
Installation
1.
Slide blower onto motor shaft until hub is
protruding 1/8".
Fig. 23
2.
Tighten set screws ( Fig. 22) on blower hub.
3.
Install snorkel (1, Fig. 21) and baffle panel (2, Fig.
21).
4.
Install racks.
5.
Check oven for proper operation.
F45598 (0616)