JVC DR-MV1 Instructions Manual page 90

TROUBLESHOOTING
90
EN
Playback (VCR Deck)
The VCR deck can not be operated.
● The VCR deck is not selected.
]Press VCR/DVD repeatedly so that the VCR lamp lights up on
the unit.
The tape will not rewind or fast-forward.
● The tape is already fully rewound or fast-forwarded.
]Check the cassette.
The playback picture does not appear while the tape is running.
● The TV is not set to the AV mode.
]Set the TV to its AV mode.
Noise appears during visual search.
● This is normal.
Noise appears during normal playback.
● The automatic tracking mode is engaged.
]Try manual tracking. (
The playback picture is blurred or interrupted while TV
broadcasts are clear or "USE CLEANING CASSETTE" message
appears on the screen.
● The video heads may be dirty.
]Use a dry cleaning cassette ECL-3F, or consult your JVC dealer.
Breaks are noticeable in Hi-Fi soundtrack.
● The automatic tracking mode is engaged.
]Try manual tracking. (
Recording (DVD Deck)
The desired programme cannot be recorded.
● The channel position does not correspond to that in the
receiving area.
]Set the correct channel position for the receiving broadcast.
( pg. 83)
Recording cannot be made.
● No disc or a disc not being compatible with the unit is loaded.
]Load a recordable disc on the unit. (
● The disc loaded is not formatted.
]Format the disc. (
● A finalised DVD-R disc is loaded.
]Recording cannot be made on finalised discs. Load a recordable
disc on the unit.
● The disc is full or does not have enough space for the
programme to be recorded.
]Clear unnecessary programmes on the disc or load a blank disc.
( pg. 59)
Downloaded From DvDPlayer-Manual.com JVC Manuals
pg. 51)
pg. 51)
pg. 6)
pg. 86)
Recording (VCR Deck)
During recording, the tape does not run. The VCR recording lamp
lights up on the front display panel.
● The unit is in the Record Pause mode.
Press 4 to resume recording.
Recording cannot be made.
● There is no cassette loaded, or the cassette loaded has had its
record safety tab removed.
]Insert a cassette, or using adhesive tape, cover the hole where
the tab was removed.
TV broadcasts cannot be recorded.
● "L-1", "L-2" or "F-1" has been selected as the input mode.
]Set to the desired channel.
Camcorder recording is not possible.
● The camcorder has not been properly connected.
]Confirm that the camcorder is properly connected.
● The input mode is not correct.
]Set the input mode to "F-1".
The tape is automatically rewound, then the unit is shut off.
● The end of the tape was reached during recording.
]The programme may not have been recorded in its entirety. Next
time make sure you have enough time on the tape to record the
entire programme.