JVC DR-MV1 Instructions Manual page 56

OPERATIONS ON VCR DECK
56
EN
VCR TIMER (#)
VCR/DVD
CANCEL
PROG/CHECK
ENTER
Check, cancel and change programmes
1
When the VCR timer lamp lights on the unit
Press VCR TIMER (#), then press 1.
When the VCR lamp does not light up on the unit
Press VCR/DVD repeatedly so that the VCR lamp lights up on the
unit.
2
Press PROG/CHECK to access the
Programme Check screen.
To cancel a programme
Press CANCEL (&) to cancel a
programme.
3
Press rt to select the
programme, then press ENTER. The
programme screen appears.
4
Change the settings of the desired
recording options as required.
● Refer to steps 7 – 10 in "Manual Timer
Programming" ( pg. 55).
5
Press PROG/CHECK to complete
timer correction. The previous screen
resumes.
6
Press VCR TIMER (#).
● The VCR timer lamp lights up on the unit and the DVD deck is
automatically selected. When the DVD deck is in timer standby mode,
the unit is automatically turned off.
Downloaded From DvDPlayer-Manual.com JVC Manuals
SAT
1 2 3
1
4 5 6
7 8 9
0
rtw e
When Programmes Overlap Each Other
If "PROGRAM OVERLAP" appears, you have another programme
overlapping the programme you have just made.
The Programme Check screen appears and conflicting
programmes will start blinking.
Example: Programme 1 (you have just made) and Programme
4 overlap each other.
1
Confirm the overlapping programmes. Overlapping programmes
blink on the TV screen.
2
Press rt to select the programme to modify, then press
ENTER or e.
● You can only select one of the overlapping programmes.
NOTE:
If you do not mind this overlap, press PROG/CHECK to finish the timer
programme setting. The programme with the lower programme number
will be recorded and the other one will not be recorded correctly. If no
changes are made for approximately 1 minute, the unit will return to the
normal screen.
3
Press rt to select the desired programme to be cancelled or
changed.
To cancel the programme
Press CANCEL (&).
● "PROGRAM COMPLETED" appears on the TV screen for about 5
seconds, then the normal screen resumes.
To change the programme setting
Press ENTER, then go to step 4.
4
Change the programme setting.
● Refer to steps 7 – 10 in "Manual Timer Programming" (
5
Press PROG/CHECK to check if the conflict has been settled.
Programme check screen appears.
● "PROGRAM COMPLETED" appears on the TV screen for about 5
seconds, then the normal screen resumes.
6
Press VCR TIMER (#).
NOTE:
When any overlaps remain after deletion and modification of
programmes, Programme Check screen remains showing the
conflicting programmes. In such a case, repeat the procedure above
until the conflict is solved.
pg. 55).