Jbl Cinema Sb250 Subwoofer Controls And Connections; Remote Control Functions - JBL CINEMA SB250 Owner's Manual

JBL CINEMA SB250
JBL CINEMA SB250 SUBWOOFER
CONTROLS AND CONNECTIONS
1
2
3
4
Power Indicator: When the subwoofer is in standby mode
the LED indicator is amber. When the system is turned ON the LED indicator
becomes white.
Phase Switch: This switch determines whether the subwoofer
driver's piston-like action moves in and out in phase with the speakers in
the soundbar. If the subwoofer were to play out-of-phase with the soundbar
speakers, some of the sound waves produced by the subwoofer or
soundbar could be canceled, reducing bass performance and sonic impact.
This phenomenon depends in part on the relative placement of the speakers in
the room. Refer page 6, for more information.
Wireless Pairing button and LED indicator:
Press this button to initiate wireless pairing between the subwoofer and the
soundbar. See Pairing the Units for Wireless Operation, on page 7, for more
information.
• The LED lights blue continuously when the subwoofer is on and linked to the
soundbar.
• The LED slowly flashes blue when the subwoofer is on and the wireless link
is not established between the subwoofer and the soundbar.
• The LED rapidly flashes blue during the wireless pairing process.
Power Input AC: Connect the supplied AC power cable
to this input.

REMOTE CONTROL FUNCTIONS

1
4
BASS
10
The following command buttons are included with the remote control:
1) Power indicator
2) Phase switch (0–180°)
3) Wireless pairing button
and LED indicator
4) Power input AC
2
3
5
6
7
8
9
11
12
1. Power on/Standby
2. Bluetooth
3. Aux-In (Analog)
4. Optical (Digital)
5. Audio Feedback
6. Mute
7. Volume +/-
8. Subwoofer Volume +/-
9. Harman Display Surround
10. Stereo
11. Harman Volume
Power on/Standby: To bring the JBL CINEMA SB250 to
operational mode from Standby mode, press the Power button (the power
indicator on the JBL CINEMA SB250 will turn white). To put the system in the
Standby mode, press the power button while the system is switched ON (the
power indicator on the JBL CINEMA SB250 will turn amber). If you do not press
the Power button, the JBL CINEMA SB250 will automatically go into Standby
mode approximately 10 minutes after the audio input signal stops.
Bluetooth: This button is used to set the soundbar into Bluetooth
mode. It is also the same button that will be used to pair your system with
Bluetooth-enabled devices. Use a Short Press to switch to Bluetooth source.
Press and hold to make the unit go into pairing mode.
NOTE: JBL CINEMA SB250's Bluetooth device name is
CINEMA SB250.
Aux-In (Analog): Press this button to select an Analog source.
Optical (Digital): Press this button to select a Digital source.
Audio Feedback: The Audio Feedback button on the remote
control enables/disables audio feedback. When enabled, this feature will add
an audible tone to help you recognize when these other features are engaged:
1. Bluetooth
2. Harman Volume on/off
3. Subwoofer volume control
4. Audio feedback on/off
When Audio Feedback is disabled, you will not hear any audible tone when
using these functions.
Mute: Press the mute button to mute the sound, press the mute button
again or any Volume button to release the mute control.
Volume +/-: Press the "+" button to increase volume; press the "–"
button to decrease volume.
Subwoofer Volume +/-: The Bass +/- buttons on the remote
control increase and decrease the subwoofer levels.
5